This is where I am going to track my Winter 06-07
Project. - OK so I didn't do so good keeping this up to date. I am
working on getting this updated.
I am swapping the Axles, Tranny, Hydraulic Clutch, and
Swinging Pedals. My goal is to get this done this spring.
Main reason is to get time to run it when the middle boy comes home on
leave before shipping to Iraq.
-
Specs:
-
Front Axle - Dana 30, 4.88s, Disc Brakes, OX Lockers
- going to do a tie rod flip as well.
-
Rear Axle - Dana 44, 4.88s, 11" Brakes, OX Lockers,
Warn Full Floater Kit.
-
Tranny - SM465 to a D18 with a Warn OD.
Hydrolic Clutch is a NOVAK setup that took some modifications.
That may be due to using an AA Bell Housing.
-
Swinging Pedals - AA Assembly bought used.
Pulled the T90 and gathered Parts:
|
|
|
|
'Hole' for SM465 |
|
|
|
SM465 adapted from Herm |
|
|
|
AA Bell for 225 to SM465 - No machine work needed |
|
|
|
New U bolts and Skid Spring Plates |
|
|
|
Axles Ready to swap in |
|
|
|
D30 (L) D44 (R) |
|
|
|
D44 with OX Locker - Custom Spacer Needed |
|
|
|
|
|
Hydro Clutch Parts |
|
|
|
Ready to Start Putting together |
|
|
|
D30 Installed - looks like the TR Flipp is needed |
|
|
Axles have been swapped - next is the brakes.
Drive Train - Put it together 03/18/07
|
|
|
|
Ready to Put together |
|
|
|
Opened Bottom SM465 to bolt to BH |
|
|
|
Opened Bottom SM465 to bolt to BH |
|
|
|
Novak Bracket on AA BH |
|
|
|
Novak Fit for Hydro on AA Bell |
|
|
|
Novak Hydro on STOCK BH |
|
|
|
Novak Hydro on STOCK BH |
|
|
|
|
|
AA vs Stock BH |
|
|
|
BH Ground out for Novak Hydro bracket |
|
|
|
BH with Novak Hydro bracket |
|
|
|
Note Clearance on front for Slave |
|
|
|
Novak Hydro Slave set - need to check angle |
|
|
|
Novak Hydro Slave set - need to check angle |
|
|
|
Clean area on Tranny for D18 |
|
|
|
|
|
Trim Tcase for SM465 |
|
|
|
Together |
|
|
|
Together |
|
|
Next Update - Moved the engine forward 1" and built the cradle for the SM465 to mount to.
This will allow me to put skid plates on later. Got it all plumbed, OX lines laid out, Need to rework some fenders
to clear the headers and it 'should' go back together.
|
|
|
|
Cradle Mounts |
|
|
|
Engine Moved |
|
|
|
Cradle in - pre paint |
|
|
|
Cradle on the floor |
|
|
|
SM465 sittin in it's new home |
|
|
|
Main work is done - ya, right. Maybe PLANNED work plus some :) |
|
|
|
